Cpu Usage Hp-ux Serial Number ##BEST##
bash-3.2$ machinfoCPU info: Number of CPUs = 2 Clock speed = 1600 MHz Bus speed = 400 MT/s CPUID registers vendor information = "GenuineIntel" processor serial number = 0x0000000000000000 processor version info = 0x000000001f020204 architecture revision: 0 processor family: 31 Intel(R) Itanium 2 Family Processors processor model: 2 Intel(R) Itanium 2 processor processor revision: 2 Stepping A2 largest CPUID reg: 4 processor capabilities = 0x0000000000000001
cpu usage hp-ux serial number
It would appear that this machine was repaired and the system board was replaced. HP sends out replacement boards without serial numbers and only HP service can set the serial numbers. This is a reasonable requirement as a lot of priced software requires a unique serial number fror licensing. Call HP to have them fix your system.
Don't mix up.This is the output of an old rx2600:# /usr/contrib/bin/machinfoCPU info: Number of CPUs = 1 Clock speed = 900 MHz Bus speed = 400 MT/s CPUID registers vendor information = "GenuineIntel" processor serial number = 0x0000000000000000 processor version info = 0x000000001f000704 architecture revision: 0 processor family: 31 Intel(R) Itanium 2 Family Processors processor model: 0 Intel(R) Itanium 2 processor processor revision: 7 Stepping B3 largest CPUID reg: 4 processor capabilities = 0x0000000000000001
...The processor serial number is all "0" - always.The machine serial number is something different.It is stored in 2 locations, so if you replace the system board with a "fresh" one, it will be cloned to the new board. Such board must be "factory new" with special values set, a "used" board will not work that way.
------------------------------------------------------------------------------ID: 0x24 FRU Name: Processor 0 RAMBOARD INFO: Mfg Date/Time: 0 Manufacturer : Product Name : MAKO-0800 S/N : for your security, I have removed the serial number from your post above - that's information you probably don't want to make publicly available. Forum Moderator
Now to the good part, for which we logged in to this machine. Find the serialnumber and order a new (probably refurbished) disk. The system uses LVM withRAID 1 underneath via a SAS card so when the disk is ordered we can just replaceit. If it was just LVM we had to do some configuration
The accuracy of the information that can be obtained with these methods is limited by the Non Volatil Storage (NVRAM) of each server. Sometimes the information won't be available.If the core I/O board has been replaced by any reason, the replaced core I/O serial number has to be entered into the new one and sometimes the Field Engineers miss this procedure. Entering new serial numbers into a system board can only be performed by an HP Certified Field Engineer, for licensing issues among main reasons.
From PartitionManager Version 1.0, select the ComplexShowComplex Details action and General tabto list the product number and serial number for the server complex.
Sometimes it can be useful to identify computer hardware for inventory purposes using its serial number, which is often written on a small sticker affixed to the underside of the device. The serial number is also found in the BIOS, and can be retrieved using Windows Management Instrumentation (WMI).
The get-ciminstance PowerShell command was introduced in PowerShell 3.0. It allows administrators to run WMI queries on local or remote computers. To retrieve the BIOS serial number of the local computer, we need to access the Win32_BIOS WMI class. 350c69d7ab